Compact Triple Stack Vault

ItsA_EnvyEnviado em 12 de set. de 2025

48estruturas
3Edifícios
950Descarrgas
8Apreciações

Template ID1039Guia da Consola

Apreciações: 8

Descrição

Follow the pictures attached. Step 1: - Setup you floor for the vaults. it needs to be 1 Quarter wall lower than walking floor level - Place Quarter ceiling in the back or the hole you left for the vaults to fall into Step 2: - Place and build '1st and 2nd Layer' template and break thatch wall Step 3: - Place '3rd row Final Final' template and break thatch wall Note: You can not place all three layers at the same time. the 3rd row will fall into the first row and you ill have to pick them back up Note: Both templates ate fully auto buildable provided it is not obstructed I added a normal 1 layer template in as well.

Como obter no console

Guia completo para console

Jogadores de console (PlayStation, Xbox) podem baixar e posicionar este modelo diretamente no jogo usando o mod Template Hammer Importer.

1Instalar o modOpen the in-game mod browser and search "Wikily" or "Template Hammer Importer".
2Fabricar o importadorEntre no modo Um Jogador + Criativo e fabrique o Wikily Template Importer (1 Fibra).
3Digitar o ID do modeloUse o item, digite o ID do modelo 1039 e o índice da construção e depois posicione.

Edifícios3 files

1
1st and 2nd Layer
24 estruturas
ID do modelo: 1039 · Construção: 0
2
3rd row final final
12 estruturas
ID do modelo: 1039 · Construção: 1
3
6 Vault with Snap
12 estruturas
ID do modelo: 1039 · Construção: 2

estruturas48 estruturas · 3 types

Custo de fabricação

Mais de ItsA_Envy

Ver Tudo

Torres de Torretas1k

Turret Tower

Basic Turret Tower without Anti Stego roof Mostly auto buildable only part of the internal anti-Racer will need to be manually built. (Its like 20 door frames). The second template are the turrets you place the foundi in the center part of the tower. It will line up

2,1k estruturas
2 Edifícios
7 Apreciações
VanillaPvP

Utilidade808

No Stuck - 7x7 Cryo Floor With Snap

Follow the Pictures attached. Step 1: - Build the foundation where your cryos are going to be on. - This could be either Foundation, Ceiling, Vacuums - Make sure there is a wall in the bottom left corner so that the template can snap to it (Otherwise it wont line up) Step 2: - Snap the template and Autobuild. (It will finish building on its own unless its obstructed) Step 3: - Finish the build of by placing ceilings around the cryos to make it flush with floor