No Stuck - 7x7 Cryo Floor With Snap

ItsA_Envy上传于 2025年9月11日

65结构物
1建筑
808下载
6喜欢

Template ID1034控制台指南

喜欢: 6

描述

Follow the Pictures attached. Step 1: - Build the foundation where your cryos are going to be on. - This could be either Foundation, Ceiling, Vacuums - Make sure there is a wall in the bottom left corner so that the template can snap to it (Otherwise it wont line up) Step 2: - Snap the template and Autobuild. (It will finish building on its own unless its obstructed) Step 3: - Finish the build of by placing ceilings around the cryos to make it flush with floor

主机端获取方法

完整主机指南

主机玩家（PlayStation、Xbox）可以使用 Template Hammer Importer 模组，直接在游戏内下载并放置此模板。

1安装模组Open the in-game mod browser and search "Wikily" or "Template Hammer Importer".
2制作导入器进入单人 + 创造模式，制作 Wikily 模板导入器（1 个纤维）。
3输入模板 ID使用该物品，输入模板 ID 1034 和建筑索引，然后放置。

建筑1 file

1
No Stuck Cryo Floor With Snap
65个结构
模板ID：1034 · 建筑：0

结构物65个结构 · 3 types

制作成本

ItsA_Envy的更多作品

查看全部

炮塔塔楼1k

Turret Tower

Basic Turret Tower without Anti Stego roof Mostly auto buildable only part of the internal anti-Racer will need to be manually built. (Its like 20 door frames). The second template are the turrets you place the foundi in the center part of the tower. It will line up

2.1k 结构物
2 建筑
7 喜欢
原版PvP

实用948

Compact Triple Stack Vault

Follow the pictures attached. Step 1: - Setup you floor for the vaults. it needs to be 1 Quarter wall lower than walking floor level - Place Quarter ceiling in the back or the hole you left for the vaults to fall into Step 2: - Place and build '1st and 2nd Layer' template and break thatch wall Step 3: - Place '3rd row Final Final' template and break thatch wall Note: You can not place all three layers at the same time. the 3rd row will fall into the first row and you ill have to pick them back up Note: Both templates ate fully auto buildable provided it is not obstructed I added a normal 1 layer template in as well.