İçeriğe geç
WikilyWIKILY
Tüm oyunlar22 viki · oyununuzu seçin
22
WikiYapı Şablonları

Oyun değiştir

22 viki · oyununuzu seçin
Şablonlara göz at
Turret Tower görünüm 11 / 2

Kule MevzileriPvP

Turret Tower

ItsA_Envy18 Ağu 2025 tarihinde yüklendi
  • 2.080yapılar
  • 2Yapılar
  • 1.041İndirmeler
  • 7Beğenmeler
Template ID818Konsol Rehberi
Beğenmeler: 7

Açıklama

Basic Turret Tower without Anti Stego roof Mostly auto buildable only part of the internal anti-Racer will need to be manually built. (Its like 20 door frames). The second template are the turrets you place the foundi in the center part of the tower. It will line up

Konsolda nasıl edinilir

Tam konsol rehberi

Konsol oyuncuları (PlayStation, Xbox) bu şablonu Template Hammer Importer modunu kullanarak oyun içinde doğrudan indirip yerleştirebilir.

  1. 1Modu yükleOpen the in-game mod browser and search "Wikily" or "Template Hammer Importer".
  2. 2Importer'ı üretSingleplayer + Creative Mode'a girin ve Wikily Template Importer'ı üretin (1 Lif).
  3. 3Şablon ID'sini girEşyayı kullanın, Şablon ID'si 818 ile yapı dizinini girin, ardından yerleştirin.

Yapılar2 files

  • 1

    ST 9.0 M

    1.979 yapı

    Şablon kimliği: 818 · Yapı: 0

  • 2

    ST Turrets

    101 yapı

    Şablon kimliği: 818 · Yapı: 1

    ItsA_Envy tarafından daha fazlası

    Tümünü Görüntüle
    Yardımcı948

    Compact Triple Stack Vault

    Follow the pictures attached. Step 1: - Setup you floor for the vaults. it needs to be 1 Quarter wall lower than walking floor level - Place Quarter ceiling in the back or the hole you left for the vaults to fall into Step 2: - Place and build '1st and 2nd Layer' template and break thatch wall Step 3: - Place '3rd row Final Final' template and break thatch wall Note: You can not place all three layers at the same time. the 3rd row will fall into the first row and you ill have to pick them back up Note: Both templates ate fully auto buildable provided it is not obstructed I added a normal 1 layer template in as well.

    • 48 yapılar
    • 3 Yapılar
    • 8 Beğenmeler
    • VanillaPvP
    Yardımcı808

    No Stuck - 7x7 Cryo Floor With Snap

    Follow the Pictures attached. Step 1: - Build the foundation where your cryos are going to be on. - This could be either Foundation, Ceiling, Vacuums - Make sure there is a wall in the bottom left corner so that the template can snap to it (Otherwise it wont line up) Step 2: - Snap the template and Autobuild. (It will finish building on its own unless its obstructed) Step 3: - Finish the build of by placing ceilings around the cryos to make it flush with floor

    • 65 yapılar
    • 6 Beğenmeler
    • Vanilla

    Benzer şablonlar

    Tümünü Görüntüle
    Kule Mevzileri3,4k

    UNDER WATER META BOTTOM

    overpowerd underwater floating tower. design origianly made by kak but i have edited some of it. be sure to build vaccume chambers to the desired hight and location then snap tower bottom. once the first vaccum snaps when auto building then delete the other chambers going to ground.

    • 1,7k yapılar
    • 2 Yapılar
    • 32 Beğenmeler
    • VanillaPvP
    P1AGUETVDoğrulanmış YaratıcıTribe Chief21 Eki 2025
    Kule Mevzileri2,6k

    kak new meta tower complete and made the right way

    im not the original builder but i did some tweaks to it and some build corrections. i think the og was a guy of kak. when built it will abort half way because you will have to foundation out and when the tower is built the walls will have to be brought down . if you want it to be hard for racer rushing then go from ground with double doorways 5-7 high all the way around with a dino gate box

    • 1,5k yapılar
    • 2 Yapılar
    • 25 Beğenmeler
    • VanillaPvP
    P1AGUETVDoğrulanmış YaratıcıTribe Chief16 Eyl 2025
    Tartışma yükleniyor...