Compact Triple Stack Vault

ItsA_EnvyЗагружено 12 сент. 2025 г.

48конструкции
3Строения
947Загрузки
8Лайки

Template ID1039Руководство консоли

Лайки: 8

Описание

Follow the pictures attached. Step 1: - Setup you floor for the vaults. it needs to be 1 Quarter wall lower than walking floor level - Place Quarter ceiling in the back or the hole you left for the vaults to fall into Step 2: - Place and build '1st and 2nd Layer' template and break thatch wall Step 3: - Place '3rd row Final Final' template and break thatch wall Note: You can not place all three layers at the same time. the 3rd row will fall into the first row and you ill have to pick them back up Note: Both templates ate fully auto buildable provided it is not obstructed I added a normal 1 layer template in as well.

Как получить на консоли

Полное руководство для консолей

Игроки на консолях (PlayStation, Xbox) могут скачать и разместить этот шаблон прямо в игре с помощью мода Template Hammer Importer.

1Установите модOpen the in-game mod browser and search "Wikily" or "Template Hammer Importer".
2Создайте импортёрЗайдите в одиночную игру + творческий режим и создайте Wikily Template Importer (1 волокно).
3Введите ID шаблонаИспользуйте предмет, введите ID шаблона 1039 и индекс постройки, затем разместите её.

Строения3 files

1
1st and 2nd Layer
24 структур
ID шаблона: 1039 · Постройка: 0
2
3rd row final final
12 структур
ID шаблона: 1039 · Постройка: 1
3
6 Vault with Snap
12 структур
ID шаблона: 1039 · Постройка: 2

конструкции48 структур · 3 types

Стоимость создания

Ещё от ItsA_Envy

Показать все

Турельные башни1k

Turret Tower

Basic Turret Tower without Anti Stego roof Mostly auto buildable only part of the internal anti-Racer will need to be manually built. (Its like 20 door frames). The second template are the turrets you place the foundi in the center part of the tower. It will line up

2,1k конструкции
2 Строения
7 Лайки
ВаниллаPvP

Утилитарные808

No Stuck - 7x7 Cryo Floor With Snap

Follow the Pictures attached. Step 1: - Build the foundation where your cryos are going to be on. - This could be either Foundation, Ceiling, Vacuums - Make sure there is a wall in the bottom left corner so that the template can snap to it (Otherwise it wont line up) Step 2: - Snap the template and Autobuild. (It will finish building on its own unless its obstructed) Step 3: - Finish the build of by placing ceilings around the cryos to make it flush with floor